Large galvanized wire selection of high quality low carbon steel wire through automatic mechanical processing of a metal screen, in the construction can enhance the bearing capacity of the ground part: in the room, the garage workshop, the ground load is large, heating network can improve the overall strength of the ground layout layer, avoid cracks, subsidence and so on. Galvanized wire can avoid cracking on the ground: galvanized wire is necessary to be placed in the center of the detailed tube is very good, the reason to crack the ceramic tile broken without barbed galvanized wire, the second is too thin on the concrete, concrete pouring should be above 4~5cm.
Processing technology: Large coils of galvanized wire are iron wire or steel wire again cold processing commodities. Through the plate shell, pickling, washing, saponification, drying, drawing, annealing, cooling, pickling, washing, galvanizing line, packaging and other procedures. Surface treatment: wire and steel wire production throughout the use of wire drawing technology or galvanized treatment. Products by hot dip plastic technology. Galvanized wire sheet can also avoid cracking on the ground as well as wire mesh, and enhance the bearing capacity on the ground.
Galvanized wire raw material: high quality low carbon steel or stainless steel. The main ways to use galvanized wire to pull reinforcement are: figure eight, inverted figure eight, cross, and shape or reverse shape and so on. Each kind of pull way can be used alone, also can use two or more kinds of combination. The pull should be as symmetrical as possible. When pulling reinforcement, the single or double strands of galvanized wire will be wound back and forth between the two bolts of the goods and the vehicle, and the galvanized wire should be pulled tight so that the tightness of each strand is as consistent as possible, and the rest of the wire is inserted and wound in its own rope rod, and the rest of the wire is twisted with a wring rod, and the rest of the tail is toward the car.
The pulling position on the cargo should be reasonably selected. When used to prevent horizontal movement of goods, the pull position should be as low as possible, and when used to prevent overturning of goods, the pull position can be appropriately selected higher. The diameter of galvanized wire for pulling shall not be less than 4mm, and the diameter of galvanized wire for binding shall not be less than 2.6mm. Galvanized wire shall not be used as waist hoop pressure reinforcement, generally not used as a whole binding. The galvanized wire shall not be damaged when wringing tightly. It is forbidden to use the operation method of wrapping more than two strands of galvanized wire at one time.
Post time: 17-01-22