The use of hot wire: reasonable selection of goods on the pull direction. To avoid horizontal movement of goods, the pull direction should be as low as possible. Used to avoid overturning goods, the pull direction can be appropriately high. Use galvanized iron wire, pull the method that pull reinforcement basically has: figure 8, inverted figure 8, cross, shape or reverse shape. All kinds of pulling methods can be used alone, or two or more than two kinds of combination. The tension should be symmetric.
Pull reinforcement, the single or double strands of galvanized iron wire in the goods and vehicles between the reciprocating around the two tie nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand as far as possible common, the rest of some cross around their rope rod, the use of the wring rod wring, the rest of the tail towards the car. The galvanized iron wire shall not be damaged when wringing tightly. It is forbidden to use more than two strands of galvanized iron wire to surround the operation method at one time. The diameter of galvanized iron wire for pulling shall not be 4mm smaller, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
Galvanized iron wire should not be used for waist band compression reinforcement, usually not as a whole binding. Warehouse galvanized wire is used to block and distinguish regional function, warehouse galvanized wire is one of the first use of galvanized wire, warehouse galvanized wire is the first layout features as follows: Column + net frame, column to choose square steel pipe for the most, galvanized wire frame is also small square tube as the data, column and net frame corresponding to the position are welded connecting lug (flat iron), column and net frame through the connecting lug bolt fixed, the bottom of the column welding bottom plate, column bottom plate through the expansion bolt and fixed on the ground.
Post time: 01-03-22