(1) Packaging and bundling electro galvanized shaft wire ordering method: ① should reasonably select the pulling position on the goods. When it is used to avoid horizontal movement of goods, the pulling position should be as low as possible; To avoid overturning the goods, the pulling position can be appropriately high. ② The main methods of reinforcement using galvanized iron wire [1] are: eight-figure, inverted eight-figure, cross, and reverse and so on. Various pulling methods can be used alone, or two or more can be used. The pull should be symmetrical. ③ Pull reinforcement, the single or double strands of galvanized iron wire in the goods and vehicles between the two tie nodes reciprocating around, and should pull the galvanized iron wire to make the tightness of the strands as common as possible, the remaining some cross around their own rope rod, the use of the stick to tighten, the tail towards the car.
(2) Packaging and bundling galvanized wire ordering precautions: ① the galvanized wire shall not be damaged when twisted. ② The operation method of using more than two strands of galvanized iron wire to wrap around at one time is prohibited. ③ The diameter of galvanized iron wire for drawing shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm. ④ Galvanized iron wire shall not be used as a compression reinforcement of the waist band, and is usually not used as an overall binding. Warehouse galvanized wire is mainly used to block and distinguish the regional function, warehouse galvanized wire is one of the primary use of galvanized wire, warehouse galvanized wire layout features are as follows: layout: The column mesh frame is mostly made of square steel pipes, and the frame of galvanized wire is also made of small square pipes. The column and mesh frame are welded with connecting lugs (made of flat iron) in the corresponding directions. The column and mesh frame are fixed by bolts on the connecting lugs, and the bottom of the column is welded with bottom plates, and the bottom plates are fixed with expansion bolts on the ground.
Post time: 13-09-23